xboxscene.org forums
OG Xbox Forums => Software Forums => Xbox Bioses => Topic started by: skat on September 22, 2003, 11:56:00 PM
-
when I write to my bios using x2cable it gives me a error sync =6 message does anyone know what this error is or is there a place that has a list of the errors
I also tried to use the executer bios manager but I got errors after it went through the writing phase the eror said
verification failed at 000000 : Read [ 00] expected [09]
can someone please give me a hint as to what I'm doing wrong or what I can do to fix my problems it's seems all I have had since I decided to install my mod is bad luck and I have had about enough of wasting time doing the same things over and over
I have tried a few different flashers and all came back with some sort of error the usb is fine because I can see the red light come up when I plug it into the usb port, the cable seems to be working to some degree because when I try and get info on the mod while I have cable b setup I get couldn't find chip errors BUT if I use the cable that I am currently using it gives me the following message
manufacturer code00 device code00 <~!~~~~ is that what I am suposed to see
if anyone can help me with this I would greatly appreciate it as I really don't know where to go from here
I have an xbox v1.1 and have a xecuter 2.2 lite chip I am also using the standard external programer
This post has been edited by skat: Sep 23 2003, 06:57 AM
-
bump
-
bump