xboxscene.org forums

OG Xbox Forums => Software Forums => Xbox Bioses => Topic started by: neo-dilly on July 29, 2003, 05:44:00 AM

Title: Used Config Magic, Screen Went Blak/white
Post by: neo-dilly on July 29, 2003, 05:44:00 AM

either use enigmah videomode switchdisc or use ConfigMagic to do a On-The-Fly Edit EEPROM and where it says Video & Xbe region, if it says NTSC, Region ?, make it say Pal, Region 4.

I do not accept responsibility for any damage caused while tinkering with your xbox

Title: Used Config Magic, Screen Went Blak/white
Post by: joestb on July 29, 2003, 06:10:00 AM

It says pal region4, but the image is ntsc...

Title: Used Config Magic, Screen Went Blak/white
Post by: neo-dilly on July 29, 2003, 06:35:00 AM

that sounds extremely odd try these things...

1) check wether pal-60 is enabled in MS Dash under settings etc

2) what connection r u using from xbox 2 tv cables might be damaged...

3) nothing of above works so backup your eeprom either using config magic or EvoX and send it me at this email address dillyfro[at]myrealbox.com

you might have damaged the av port in the xbox itself (solder gone on some traces connecting to it or the connector itself)