xboxscene.org forums

OG Xbox Forums => Software Forums => XboxMediaPlayer => Topic started by: Fuzzy on February 24, 2003, 05:47:00 PM

Title: Need Help To Get Xbmp 2.3 Working
Post by: Fuzzy on February 24, 2003, 05:47:00 PM

i have the same problem only im running mine from a cd with the media on it

Title: Need Help To Get Xbmp 2.3 Working
Post by: Klaus on February 26, 2003, 01:49:00 PM

Are you both using EvoX or XBMP as your dash? If you're using EvoX, don't put the .cut file on your C drive.

I run EvoX and had XBMP 2.3 running fine, then realised the .cut file was missing. Found the .cut file and stuck it on the C drive, from then on XBMP didn't work. Got rid of the .cut file and XBMP started working again. As far as I can see, the .cut file is only if you want to use XBMP as your dash.

Klaus

Title: Need Help To Get Xbmp 2.3 Working
Post by: Fuzzy on February 26, 2003, 05:43:00 PM

im pretty sure the .cut file isnt there

Title: Need Help To Get Xbmp 2.3 Working
Post by: cube on February 26, 2003, 11:05:00 PM

@Fuzzy:

Did you manage to get it working from CD yet?? Might try to set it up tonight see if I run into the same trouble if you didn't got it up and running...

Title: Need Help To Get Xbmp 2.3 Working
Post by: cube on February 27, 2003, 10:51:00 AM

@Fuzzy:

Hi Fuzzy,

I posted a stripped version of my config.xml in this thread:

Stripped Config.xml

If you use this config (or add some shares, make sure you use your IP addresses etc.) you have a version that works from disc! I tested it with my full version, but I only removed a couple of shares in this config, so that doesn't make any difference...

I didn't add a movie but you can either swap the disc (if your mod chip supports that) or put it somewhere on the disc in a folder and go there with through the UDF folder... (tried to browse the DVD and could do it under UDF)

I just realized how do you make the disc?? Do you just burn it?? Or do you use GDFImage (or Isomaker)??? That is the way I did it and it works..

So:
- make a folder with the latest XBMP
- use my config.xml
- add another folder with your movie
- make an image with ISOmaker
- Burn it with Prassi Primo DVD (or Record Now Max or the latest Nero (I heard it works, didn't try though) (Prassi works also with CD-RW, it treats it the same)
- No .cut file on c:\  (didn't try if it matters if I put it there...
Now you'll have a working disc with movie, you can also swap if you want to play movies or mp3's from another disc...

Hope this helps you out..

Regards,

Cube

Title: Need Help To Get Xbmp 2.3 Working
Post by: x_rider on March 01, 2003, 06:19:00 PM

It was the cut file that was messing things up....too funny. That booted up xbmp fine, now all I have to do is look at my evox.ini and look where to place my movies...lol

thanks for the help guys!