xboxscene.org forums

OG Xbox Forums => Modchip Forums => TSOP flashing => Topic started by: ggtech on April 05, 2005, 03:29:00 PM

Title: Need Help With Mobo Swap
Post by: ggtech on April 05, 2005, 03:29:00 PM

i hope im posting in the right erea


here is my question, i modded a freinds xbox a while back, he went and baught a brand new box, turned out to be a 1.6. so we swapped a mobo and power suply with a older  extra x-box i have. it was a 1.1.  he wanted it now, and he lost reciept. so this salution worked. his box is working awsome for half year now.

so here is my problem. i just went to assemble the 1.6 mobo and power supply into the 1.1 case. it all goes together nice. BUT, wont power on.

does any one have any idea??

has anyone else done this??

thanks. <

Title: Need Help With Mobo Swap
Post by: acemilo on April 05, 2005, 03:47:00 PM

Yup, you shorted out the mobo.  You cannot put a 1.6 mobo in a case besides a 1.6 case because of the difference in the screw holes.  Find the one thats touching the mobo and dremel it out and hope that its not dead. <

Title: Need Help With Mobo Swap
Post by: ModdingManiac on April 05, 2005, 03:59:00 PM

Yeah the 1.6 mobo won't fit on a 1.0-1.5 case without some modificaton. Luckily most likely all you did was kill the transistor which can be replaced:

here is moer info on it:
http://downloads.ozxodus.com/Guides/Xbox_v...esurrection.pdf

you can get the part here:
http://secure.llamma.com/catalog/product_i...products_id=233 <

Title: Need Help With Mobo Swap
Post by: ggtech on April 05, 2005, 04:04:00 PM

Ok thanks.

i will have a look at the contacts points. i did notice there are some tabs on the bottom of the box, almost looks like they are ment to touch the mobo.

its just funny that the old mobo in the new case worked no problem.

 <

Title: Need Help With Mobo Swap
Post by: ggtech on April 05, 2005, 04:09:00 PM

thanks again, i will check the trasistor. and replace.

what are the mods needed to make the mobo work in the old box???

 <

Title: Need Help With Mobo Swap
Post by: ModdingManiac on April 05, 2005, 04:58:00 PM

There is a  screw that is missing is on the 1.6 board. The 1.0-1.5  board has a screw hole between the GPU and the video connector. The 1.6 does not so you need to remove the metal shielding where that screw normally goes. Also where the video connector goes on the back of the xbox there are 2 plastic screw holes (one on each side of the connector), sand them or cut them down since they are little to high
 <

Title: Need Help With Mobo Swap
Post by: ggtech on April 05, 2005, 09:21:00 PM

Thanks Maniac you have  been alot of help.

ill have to order the transistor. ill mod the case
while im waiting for the trasnsistor to arive.
and hopefully im back in buisness.

thanks <