xboxscene.org forums

OG Xbox Forums => Modchip Forums => TSOP flashing => Topic started by: protowars on December 20, 2003, 01:41:00 PM

Title: Tsop Flash And Smoke And Fire
Post by: protowars on December 20, 2003, 01:41:00 PM

i flashed my tsop and used a switch to change between the bioses

it worked for while

but then when i mounted the switch in back by drilling hole

and resoldered the wires

when i put the switch at vcc it boots to xecuter bios

when i put it on a19, it reboots and smoke

not sure wut i can do now

the middle wire is connected to the metal case

Title: Tsop Flash And Smoke And Fire
Post by: lordvader129 on December 20, 2003, 07:25:00 PM

literal smoke? are you sure you connected to a19?


wait...middle wire to case? the middle wire should go to a19, and the outer 2 one goes to ground (case or screw) and the other to 3.3v VCC

is possible that your grounding the 3.3v, which would just heat up and could be melting the insulation on the wire, causing smoke

This post has been edited by lordvader129: Dec 21 2003, 03:26 AM

Title: Tsop Flash And Smoke And Fire
Post by: OVerlordI on December 20, 2003, 08:09:00 PM

Ya, ive done this before, was scary when i saw smoke rising from my xbox.

OVerLoRDI

Title: Tsop Flash And Smoke And Fire
Post by: psxguy on December 21, 2003, 04:26:00 AM

yep you most likely got your wires crossed as this happened to me too.

Title: Tsop Flash And Smoke And Fire
Post by: PsiDOC on December 21, 2003, 04:38:00 AM

On a technical note. Direct shorting your 3.3v line can cause damage to the Power Supply.
May I suggest that you redo your switch lines and then monitor the 3.3 volt line during a boot up (use a digital volt meter) if it dips more than 0.15 - 0.2 volts I'd think about changing the supply for a new one.
Regards,
Psi