OG Xbox Forums => Modchip Forums => Team Xecuter Chips (Xecuter1, Xecuter2 & Xecuter3) => Topic started by: The LukeMan on January 07, 2004, 09:48:00 PM
Title: 1.0 Solder Filled
Post by: The LukeMan on January 07, 2004, 09:48:00 PM
Yep ther filled the lpc points but ive been reading the x ecuter 2.3b lite + should still work without desoldering the points is this true ?? :o
sorry thought i was in hardware forum <_<
This post has been edited by The LukeMan: Jan 8 2004, 05:49 AM
Title: 1.0 Solder Filled
Post by: bleugh on January 08, 2004, 01:33:00 AM
????
if you have a pin, it still needs to go in a hole,
if you dont have a hole then two choices,
1) make a hole (desolder) 2) solder wires into the hole
either way some soldering or desoldering is needed!
Title: 1.0 Solder Filled
Post by: DynaMight on January 08, 2004, 03:14:00 AM
Just use the wire install, No need to remove any solder. It's prolly easier than the header pin too. You could probably do the whole thing without using any solder.
Title: 1.0 Solder Filled
Post by: deviation56 on January 08, 2004, 03:16:00 AM
i have a 2.3 lite + and a 1.0 xbox with the holes filled and i never had to desolder anything...
Title: 1.0 Solder Filled
Post by: The LukeMan on January 08, 2004, 03:16:00 AM
well im going to try dangling the pins over the lpc ports and that way it should make a contact althought it could possibly not be 100% stable
Title: 1.0 Solder Filled
Post by: moistness on January 08, 2004, 03:21:00 AM
QUOTE (The LukeMan @ Jan 8 2004, 02:10 PM)
well im going to try dangling the pins over the lpc ports and that way it should make a contact althought it could possibly not be 100% stable
If you are talking about a pogo install, then it should "work" as well as any pogo install!
Nothin beats a good header pin install though! ;)
Title: 1.0 Solder Filled
Post by: The LukeMan on January 08, 2004, 03:24:00 AM
Yep its an xecuter 2.3 lite + chip non solder so i plan to place the pins carefully over the lpc points that are filled then screw it in it better work :lol:
Title: 1.0 Solder Filled
Post by: moistness on January 08, 2004, 03:27:00 AM
just realised that you have posted this twice, both times in the wrong forums!
one in general h/w, one in case + h/w modding, should be in newbie chat!
*slap*
Title: 1.0 Solder Filled
Post by: The LukeMan on January 08, 2004, 03:35:00 AM
s0orry about that
Title: 1.0 Solder Filled
Post by: FunkmaztafoX on January 08, 2004, 06:55:00 AM
i have a v1.0 and didn't have to solder or desolder anything and my lpc's are filled
Title: 1.0 Solder Filled
Post by: The LukeMan on January 09, 2004, 07:27:00 AM
Hello yeh can the xecuter 2.3b lite + non solder chip be fitted on to these filled ports in my xbox see below