xboxscene.org forums

OG Xbox Forums => Modchip Forums => Team Xodus Chips (Xenium) => Topic started by: TheSchonk on January 05, 2006, 04:33:00 PM

Title: Xenium Spice
Post by: TheSchonk on January 05, 2006, 04:33:00 PM

What is the usb port for that comes with the xenium spice chip and how do you install it?

Title: Xenium Spice
Post by: EverestX on January 05, 2006, 05:54:00 PM

It's acctually for several things. A. Flashing bios off a flash/thumb drive b. using a thumb drive as memmory card to transfer xploits etc to xboxes c . for a usb mouse or keyboard

You stick it in the controller port to "install" it

Title: Xenium Spice
Post by: TheSchonk on January 05, 2006, 07:01:00 PM

How do you stick it into the controller port?

Title: Xenium Spice
Post by: TheSchonk on January 05, 2006, 11:04:00 PM

bump

Title: Xenium Spice
Post by: Gimpishi on January 06, 2006, 06:29:00 AM

You put the little circuit board with the 4 gold wires face up and push it into the port. It fits rather snugly underneath the platic piece in the center of the port. When its all the way in the usb port will stick out approximately a quarter inch, not much at all...

Title: Xenium Spice
Post by: TheSchonk on January 06, 2006, 12:36:00 PM

Does it work for usb hard drives?

Title: Xenium Spice
Post by: TheSchonk on January 06, 2006, 12:58:00 PM

Thanks

Title: Xenium Spice
Post by: Gimpishi on January 06, 2006, 03:13:00 PM

That little USB thing mounted on the square board is an adaptor, not a storage device. Any device that uses USB can connect through it... such as usb keyboard and mouce for linux. Or a usb memory stick for flashing a bios to the mod chip. All this little thing does is rearrange wires so you can conveniently connect usb devices. A usb hard drive should work, but i have not tried it. If linux can run it, then chances are it will work through the USB adaptor.