xboxscene.org forums

Off Topic Forums => Other Platforms => Personal Computer (PC, MAC, etc) General Talk => Topic started by: kirky1991 on August 23, 2010, 10:47:00 AM

Title: Wip: My Netgear Wgr614 V5 Cooling And Switch Mod
Post by: kirky1991 on August 23, 2010, 10:47:00 AM

Two connections will be Negative One will be positive.

You'll have to cut the trace to the + or negative then solder a swtich into the circuit. Or you culd cut the power cable and add a switch like that.

Title: Wip: My Netgear Wgr614 V5 Cooling And Switch Mod
Post by: kirky1991 on August 24, 2010, 10:49:00 AM

No. Cut the trace, One side goes to one connection on the switch, the other side goes to the other connection on the switch.

CODE

------------ / -------------     < Cut trace


-------  [Insert Switch]      ---------    solder either end of the trace to the switch

Legend

CODE

--------               Positive Trace
/                        Cut
[Insert Switch]    Switch

If you dont understand this still....I could literaly do it, take a picture and upload it/show you.

To be honest, If you cant do this, I dont think you should be messing around with electronics at this moment in time.

Title: Wip: My Netgear Wgr614 V5 Cooling And Switch Mod
Post by: bigboys on August 24, 2010, 08:52:00 PM

i was in the same boat !

Title: Wip: My Netgear Wgr614 V5 Cooling And Switch Mod
Post by: bucko on September 03, 2010, 03:39:00 AM

moving to a better place..nice mod my dlink talktalk routers overheated to but i complained to talktalk and they sent me another manufacture router and all is good..increased speeds to and have a power switch