Post by: Harbinger076 on December 07, 2010, 12:59:00 PM
QUOTE(intruder2k @ Nov 28 2010, 07:42 AM) 
Hi,
I have a problem with my Cygnos Chip, I think i f***ed it up. I tried to update my freeboot image, after writing the NAND (sucessful) the Xbox got RROD. I think i powered the box on and was still connected via usb.
My problem now is that i am not able to flash any new nand, because the cygnos is always a unknown device in windows. Is there a solution for that problem? And what could be happened to the chip? Is the xbox nand damaged, or can i just buy a new cygnos, solder it in and it will work again?
i am having the same issue at this moment.. windows says "unknown device" and team cygnos forums are down..
Post by: Dra60nSlayer on December 15, 2010, 12:34:00 PM
disconnect power cable then press powerbutton
set your chip to on..(switch towards USB)
connect usb and start toolbox
then supply power
this would trigger debug/bootload mode (led will blink)
and windows might see it again
Post by: gab76 on January 01, 2011, 03:39:00 PM