xboxscene.org forums
OG Xbox Forums => Modchip Forums => Team Xodus Chips (Xenium) => Topic started by: _InFeRnO_ on February 25, 2006, 04:19:00 AM
-
Alright i got a v1.6 console with a duox2 chip installed and decided i wanted to put a xenium ice chip in it. I added the two additional pins onto the pin headed that the xenium require but for some reason i almost always get a constant frag. Sometimes it will work and other times it will not. I plugged in the additional wire loom, the one with the d0 and the optional ground, and figured out that if i solder the ground wire to the d0 spot on the chip it works just fine. My question is will this mess anything up or is the chip needing additional grounding? I tried to solder the ground onto a screw hole but it continued to frag, so i just resoldered it back onto the d0 point. Any help appreciated. TIA!
-
It could be that you have bad LPC connections or that the D0 is not getting good contact. Try those both. Also, since you have a v1.6 make sure you have done the LPC rebuild correctly.