Topic: Can't Flash St Tsop (Read 184 times)

Ian · « **on:** September 08, 2003, 04:05:00 PM »

I've recently been trying to flash the TSOP on my xbox. It's a version 1.1 with an ST. I've correctly bridged the two sets of points with solder, and I've checked, rechecked, and checked my connections again. They look perfect. The problem is when I boot up EvoX (with the font exploit properly installed) and select flash bios, it just says "Flash Not Writeable"

. I've tried everything, but I don't know what's wrong. Do I have to flash with raincoat? I haven't tried that yet. Any ideas?

Oh, the bios I'm trying to flash is a 1MB X2 4976.02, so it should work.

This post has been edited by Ian: Sep 8 2003, 11:06 PM

venturahighway · « **Reply #1 on:** September 08, 2003, 07:35:00 PM »

Got:
Flash = 0x20f1,"ST - M29F080A",0x100000
Flash = 0x20B0,"ST 29F002",0x40000
or maybe
Flash = 0xbf61,"SST - 49LF020",0x40000
in your evox.ini ?

incansun · « **Reply #2 on:** September 08, 2003, 07:44:00 PM »

I'd try to reflash with the latest raincoat, I believe its the .501. Also, if you get a read error, than check your soldering.

Ian · « **Reply #3 on:** September 09, 2003, 05:35:00 AM »

OK, I'll try both when I get home. Thanks for the input.

ouiji · « **Reply #4 on:** September 09, 2003, 09:20:00 AM »

i got he same problem..... i have st chip in the ini file guess im back to lookin att he solder points,
removed solder and cleaned with alchol and resoldered and it works great.

This post has been edited by ouiji: Sep 9 2003, 06:09 PM

Ian · « **Reply #5 on:** September 11, 2003, 06:27:00 PM »

Hey everybody, just wanted to let you know that my TSOP is flashed and 100% working with an X2 BIOS

After hours (literally) of resoldering and software troubleshooting and "Flash Not Writeable Errors", I was about to just say "screw it" and give up. But then I read how I should clean the points with isopropyl alcohol. So I removed all my solder, cleaned the points with the alcohol, applied flux, and resoldered. Woohoo! It flashed in EvoX perfectly! So if any of you are having problems soldering the points so you can flash your TSOP, clean the points with isopropyl alcohol before you start. That was my problem.

--Thanks for your helpful comments.

savage007 · « **Reply #6 on:** September 15, 2003, 01:03:00 PM »

Hi, i too have tried to solder the two points, but something has
gone wrong, now i cannot see the two points anymore ( the ones near the lpc points ),
first there were two little bulging points of solder but now they are gone.

Can i fix this with some cleaning with alcohol and then flux and solder again??

This post has been edited by savage007: Sep 15 2003, 08:29 PM

venturahighway · « **Reply #7 on:** September 15, 2003, 01:09:00 PM »

You may have removed the solder from the pads, or ripped them off. If they are gone follow the traces to their source and run a wire. PM me if you need help.

Author Topic: Can't Flash St Tsop (Read 184 times)