xboxscene.org forums

Pages: 1 2 3 [4]

Author Topic: Guide: Modding Xbox With The X2.6  (Read 510 times)

thepurpledino

  • Archived User
  • Jr. Member
  • *
  • Posts: 76
Guide: Modding Xbox With The X2.6
« Reply #45 on: November 17, 2004, 11:06:00 AM »
nice pics Whiffin!!!!

Notice to new installers - Please see that Whiffin has opted to use FLUX on his solder points (brown sludge on the LPC). You will find that this will make the job much easier!
Logged

whiffin

  • Archived User
  • Sr. Member
  • *
  • Posts: 378
Guide: Modding Xbox With The X2.6
« Reply #46 on: November 18, 2004, 05:21:00 AM »
QUOTE (mR 54 @ Nov 17 2004, 02:51 PM)

No the 5V wire is only for the 1.6 xbox's.

Flame me if im wrong.

Perfect - thanks

QUOTE
nice pics Whiffin!!!!

Notice to new installers - Please see that Whiffin has opted to use FLUX on his solder points (brown sludge on the LPC). You will find that this will make the job much easier!


Thanks

And for noobs - you can buy solder with flux in it already ...  wink.gif
Logged

$langer

  • Archived User
  • Full Member
  • *
  • Posts: 222
Guide: Modding Xbox With The X2.6
« Reply #47 on: November 25, 2004, 12:32:00 AM »
I'm just doing an install now and I was wondering if I can solder the resistor in now while I got the motherboard out but leave the trace un-cut until I test if the modchip/xbox works.  Or will the Xbox not be able to start up with the resistor soldered in?  I don't think it will matter since the current will not even pass through the resistor until the trace is cut... Just wanted to make sure.

Thanks!
Logged

OcnewB

  • Archived User
  • Full Member
  • *
  • Posts: 209
Guide: Modding Xbox With The X2.6
« Reply #48 on: December 15, 2004, 03:13:00 AM »
bump
Logged
Pages: 1 2 3 [4]
« previous next »