Topic: Want To Re-flash Bank 3/4 (Read 110 times)

Sandman8611 · « **on:** February 21, 2004, 03:13:00 PM »

I just installed the Xecuter2 Pro to my system, and made 1 minor mistake...I started to flash banks 3/4 with the new bios and turned off the power. This corrupted the native Cromwell in those banks. I then took a few deep breaths (after banging my head on the countertop) and successfully flashed banks 1/2.

I know, I know...another NOOB mistake!

I tried to flash 3/4 again, but I only get FRAG on boot.

The Box is working in both Mod mode and Un-Mod mode, and all functions are available in both.

My questions is: Is it possible to flash 3/4 again? Again, I have the pro version, so I have the LPT port available. I just don't want to go into this blind and would like some suggestions and help. Thanks! <

Muntzster · « **Reply #1 on:** February 21, 2004, 03:31:00 PM »

i screwed up a flash before.. i think anyways and i just used my programmer and erased the chip and reflashed it.. try that

This post has been edited by Muntzster: Feb 21 2004, 11:32 PM <

duudfromnorway · « **Reply #2 on:** February 21, 2004, 03:33:00 PM »

you have programmer.. :rolleyes: what`s up!!
why flash 3/4? flash 2 x 512kb with flashx, then you`ll have dual bios, and keep cromwell in one of them.... <

Muntzster · « **Reply #3 on:** February 21, 2004, 03:35:00 PM »

hahaha i love the programmer... none of the cd bullcrap <

Author Topic: Want To Re-flash Bank 3/4 (Read 110 times)