Print

[dikki dik]

Hi

i downloaded "uxe-complete.bz2" but how can i change the bios version to evolutionx M8 plus in here. And do i have to do something else to make it work correctly. It's for a version 1.6 xbox.

thx    

[slrhsapple]

Find where the package store the dashboard, i think it is in fonts but check.  use evtool to edit the bios so it look for the location and name of the dashboard.  then save the bios.  Then either rename the bios that you just modified to the bios that was in your uxe package or open boot.cfg and tell it it load the bios that you just editted. upload the bios

Anyway, the above assume that the package uses pbl but I think the uxe package that you used uses nkpatcher instead so here are the steps.

1.  Download PBL-Metoo and extract it.
2.  Use Evtool to edit the bios to point to the location and name of your dashboard
3.  Open up the boot.cfg using notepad or wordpad to verify that the bios that it will load is the bios that you just edited, if not, change the name to the name of the bios you just edited.
4.  Rename the default.xbe in PBL-Metoo to the name that NKPatcher or PBL in your package is using.
5.  Upload PBL-Metoo to where your your previous PBL or NKPatcher is and overwrite if neccessary.  You don't have to upload evtool or source folder.

This post has been edited by slrhsapple: Nov 29 2004, 07:35 PM

[dikki dik]

ok but what is my xbox dash cause if i open the map uxe i only have the file

xboxdash.xbe (i think this isnt the dash from evox or is it?? )
bert-generic.xtf
ernie.xtf
evox.ini
ex.xbe
nkpatcher.xbe

i also cant find the bios file in here?

[slrhsapple]

ex.xbe is your dash..
The uxe package you used uses nkpatcher so you if you want to use a bios, you need to switch to pbl metoo.

QUOTE

Anyway, the above assume that the package uses pbl but I think the uxe package that you used uses nkpatcher instead so there are the steps. 1. Download PBL-Metoo and extract it. 2. Use Evtool to edit the bios to point to the location and name of your dashboard 3. Open up the boot.cfg using notepad or wordpad to verify that the bios that it will load is the bios that you just edited, if not, change the name to the name of the bios you just edited. 4. Rename the default.xbe in PBL-Metoo to the name that NKPatcher or PBL in your package is using. 5. Upload PBL-Metoo to where your your previous PBL or NKPatcher is and overwrite if neccessary. You don't have to upload evtool or source folder.

[dikki dik]

QUOTE (slrhsapple @ Nov 29 2004, 05:25 PM)

ex.xbe is your dash.. The uxe package you used uses nkpatcher so you if you want to use a bios, you need to switch to pbl metoo.

THX