Print

[krayzie]

QUOTE(ikecomp @ Jun 27 2005, 08:01 PM)

how do i point the kernal patcher to evox?

[Hexx]

Oh, that's why I got error 21 from every .xbe I ran from my secondary dash.
Can you elaborate where I can get this bios loader and kernel patcher? After that, hopefully I can figure most of the rest out on my own.
Thanks.

[krayzie]

they are in the usual places.

[Hexx]

OK, there's fbl, pbl, and nkpatcher. Which is a good choice?

[Hexx]

I'll use nkpatcher. How do I get it to load with the .xbe?

[krayzie]

well you need to fill in the bootpath in the config file from the source and then assemble with nasm. It might be easier to get the pbl metoo package since then you can use the added evtool to adjust the bios so it points to the right locattion.

[Hexx]

Is there a specific tutorial for this? I am in major confusion.

[krayzie]

I'll try to put it in a simple explanation cuz it is easier then it looks. If a new bios is loaded or patched after the exploiting of the ms bios rsa key then it looks for a new dashboard. In my installer it looks for E:\dashboard\default.xbe. If you put a bios loader or kernel patcher in the tray open folder it will most likely look for C:\evoxdash.xbe as this is the most comon default bootpath. Now you can do two things. Either put your evox dashboard on C named evoxdash.xbe or you can adjust the bios or kernel patcher to boot another path (e.g. E:\dashboard\tray open\dashboard.xbe or something in that nature so it looks more clean. The kernel patcher can be adjusted by editing the source and assembling. A bios can be adjusted by opening it in special tool (for x2 bioses that xbtool and for evox bioses it's evtool)