Topic: Solder Points On A 1.1 = No Video (Read 423 times)

crusty_punk · « **Reply #15 on:** March 19, 2012, 10:40:00 AM »

QUOTE(crusty_punk @ Mar 18 2012, 12:25 PM)

... and everything is fine...

by that I meant it stopped turning off randomly. Still can't flash it with cromwell...

Heimdall · « **Reply #16 on:** March 19, 2012, 02:14:00 PM »

Are you sure it's not:

Manufacturer ID 09 Device ID 00
!! Unknown Flash Type!!

STICKY_BUD · « **Reply #17 on:** March 19, 2012, 03:02:00 PM »

you have to use heimdall's picture with raincoat as the flasher

crusty_punk · « **Reply #18 on:** March 24, 2012, 12:48:00 PM »

QUOTE(Heimdall @ Mar 19 2012, 04:14 PM)

Are you sure it's not:

Manufacturer ID 09 Device ID 00
!! Unknown Flash Type!!

Something happened between my last post and today... now I am getting an error telling me that I am unable to flash. I have decided to just build this box into a media and emulator box. Since it's already softmodded, I really dont care. I have two 1.4's that I can work with and do what I wanted to do.

I do apologize for wasting anyone's time but I do thank everyone who has tried to help me.

shambles1980 · « **Reply #19 on:** March 24, 2012, 09:23:00 PM »

you should solder up the pads on the foxlink (where the figure of 8 connector plugs in)

Then i also like to mix up a crap load of epoxy and put it between the black plastic that the figure of 8 connects to and the heat sturdy structures nearby (not resistors or caps)
You can also use hot glue i guess..

I do that because it helps support the connector better so the solder wont break again.

Author Topic: Solder Points On A 1.1 = No Video (Read 423 times)