xboxscene.org forums

Author Topic: Tsop'ing A 1.1  (Read 182 times)

eXo

  • Archived User
  • Newbie
  • *
  • Posts: 46
Tsop'ing A 1.1
« on: December 22, 2010, 09:23:00 PM »
hey guys,
       I'm a little seasoned in TSOP flashing but now I've come across a woe.

Long story short, I bought a 2nd handie and cracked it open to find the little bypass you must set at the bottom of the 1.1 (not sharp) seems to have R7R3 snapped off! (the silver is missing with just the brown underneath)

I've has a look at those alternative points for TSOP and will have a crack at the same point topside.

(IMG:http://img.photobucket.com/albums/v32/davicoro/TSOP/points10.jpg)

my question is.. with the bottom missing (looks like it was rubbed off with force) will this affect the overall TSOP'ing ability or do I need to do some surgery on that bad contact at the bottom to make them bridge?

This post has been edited by eXo: Dec 23 2010, 05:24 AM
Logged

lordvader129

  • Archived User
  • Hero Member
  • *
  • Posts: 5860
Tsop'ing A 1.1
« Reply #1 on: December 23, 2010, 05:51:00 AM »
it should be fine, since its just a solder pad and not actually connected to anything
Logged

eXo

  • Archived User
  • Newbie
  • *
  • Posts: 46
Tsop'ing A 1.1
« Reply #2 on: December 23, 2010, 03:47:00 PM »
Logged

eXo

  • Archived User
  • Newbie
  • *
  • Posts: 46
Tsop'ing A 1.1
« Reply #3 on: December 28, 2010, 09:14:00 PM »
WiNZ!

the bottom pic of the board at the top of the yellow line connected with the blue square above it = the same as the wire trick from C7R3.

BiOS flashed...
Logged