Topic: Xbox With Intel Tsop (Read 455 times)

wup · « **Reply #15 on:** March 30, 2006, 09:03:00 PM »

Is it just me or does it look like there has been some soldering on the legs of that tsop. There is a possibility that this shop repaired it by replacing the tsop with this one.

Wup

P.S. Ive done over 100 tsop flashes never seen one of these intel's

pirichios · « **Reply #16 on:** March 30, 2006, 11:13:00 PM »

omg this is amazing an intel tsop...
even though its too early to draw conclusions
this is amazing if this is a 2 mb tsop as from what i read earlier in one of the other members posts
and turns out to be true and if someone figures how to flash this we could be looking at an eight! way tsop split
if its doable this is scary....(sick and wrong)
of course probably im just doing wishful thinking
please if its doable the gentlemen who owns this xbox can you give us a bigger pic of the motherboard as a whole asap?
we might also find that this tsop may be a part of an unknown revision version just because it looks like a 1.2 there may be differences that can officially separate it from a 1.2 (1.2b mobo revision possibility anyone?)
please dont kill me as im speculating a lot
but i think it would be cool
thanks

Sukij · « **Reply #17 on:** March 31, 2006, 03:58:00 AM »

Mainboard Picture.. for your pleasure !!!

IPB Image

caster420 · « **Reply #18 on:** March 31, 2006, 07:19:00 AM »

As stated earlier, it is not 2mb, it is 256kb, because the size of it is in kilobits (1/8th of a kilobyte).

I have found a pinout and information on how to flash and what the chip needs to have to be able to write. One of the pins must have greater than 6V to be able to write the chip. Where to go from here, i am not sure but i'll change the sheet info from pdf to an image and post here in a bit.

Caster.

caster420 · « **Reply #19 on:** March 31, 2006, 07:50:00 AM »

If you look at pin vpp in the first image, this pin must have greater than 6.5V(error in post above) to enable writing. Someone with more knowledge than me can surely flash it.

Enjoy.

Caster.

Sukij · « **Reply #20 on:** March 31, 2006, 08:12:00 AM »

More clear picture

IPB Image

caster420 · « **Reply #21 on:** March 31, 2006, 08:22:00 AM »

What watt soldering iron are you using? Looks like its a little high to be using on an xbox mobo, based on how badly you burnt it.

If you were to supply the 9th pin from the top left in the pic above with more that 6.5V and had the init strings for the chip, you should be able to flash it using raincoat or a similar application.

Caster.

Sukij · « **Reply #22 on:** March 31, 2006, 08:54:00 AM »

huh!! I better bring back to the shop.. if noone exactly know how to do it...

This is my first time try to solder these VERY VERY small point like this. So, the first brigde is look bad !!!
the second point is look much better, right .... hahahah need some experience to get use to it...

DaShiZNiT · « **Reply #23 on:** March 31, 2006, 12:40:00 PM »

you are lucky its not fraggin on you.

this is interesting, I can say Ive worked on over 150+ xboxes, ever seen or heard of that chip.

pirichios · « **Reply #24 on:** March 31, 2006, 01:08:00 PM »

Thanks for the info Caster
bummer to bad it is only a 256k TSOP
a one bios bank is cool but ....
one can only dream though (8 way TSOP *drools*)

AfterTheInsanity · « **Reply #25 on:** March 31, 2006, 03:12:00 PM »

Hey, if you dont want the box with the Intel TSOP Ill gladly take it off your hands!

AfterTheInsanity · « **Reply #26 on:** March 31, 2006, 06:09:00 PM »

Id take it only for the challenge of making it work. If you could figure out the flash codes (maybe theyre in a datasheet somewhere) for the chip, then you would be able to flash it.

Sukij · « **Reply #27 on:** March 31, 2006, 07:33:00 PM »

Hey. I'm just a newbie.

So, don't expect me to do any challenge electronic modding like putting 6V into that amazing chip that you all mentioned and told me that I will be able to flash it.. I have no clue of what you are talking about

If your guys has chance to visit Thailand (before I throw this box away), I'm very very please if you want to take it !!!

Anyway, I have to thanks all of you giving me many comments on this Intel chip.. I will always follow up this topic if in case there is any update on it.

Thank you so much..

P.S. please send email to me [email protected] if you have amazing solution for my xbox in the future...

Evox117 · « **Reply #28 on:** March 31, 2006, 08:16:00 PM »

QUOTE(Sukij @ Mar 29 2006, 01:38 AM)

no.no.. I take the picture from my own xbox... it's not a fake pict.
so, very curious that why noone or no tutorial refer to it.

use your Digi Cam and give us a little video clip of You touching...poking it or w/e I wanna know if this is real (right now im leaning twords no)

AfterTheInsanity · « **Reply #29 on:** March 31, 2006, 09:10:00 PM »

Even though we're half a world away, Im sure someone here is willing to pay you for the xbox, and even pay the shipping on it (which is customary anyways), or trade you a normal xbox for it. This is the kind of thing that even if you dont know what to do with, someone out there wants it, and you could probably make some money off it if you were that kind of person.

Author Topic: Xbox With Intel Tsop (Read 455 times)