Flash it with Raincoat .7...If that doesn't work, ur points are not soldered right...U gotta do both sets of pads on top and bottom of the board...Verify that the pads are bridged with an ohm-meter...Place ur leads on either side of the pads and see if u read 0, if u read a 1 it's not connected....
I like to place the leads on things other than the pads themselves, like i follow the trace from 1 pad to a surface mount resistor and then the other trace from the other pad to a via or something, and take my continuity measurement there, that way i know i'm not getting a false reading since the pads are so close and my leads could be touching....
