Topic: What Are The Correct Tsop Enable Points On A V1.2 (Read 108 times)

lordvader129 · « **on:** February 07, 2004, 11:25:00 AM »

2 points on the top for 1.2-1.5

Yuyu · « **Reply #1 on:** February 07, 2004, 02:39:00 PM »

Hmm I always have connected the 2 lower points in the picture above (in the yellow circle) and these 2 points on the bottom,
user posted image

for 1.2, in fact I just did this last night, if you recall lordvader129...

manatarms25 · « **Reply #2 on:** February 07, 2004, 03:28:00 PM »

I have flashed 3 1.2's I only used the 2 jumpers on the top of the MOBO I never had a problem check your connections I always scrape them good before soldering or painting this seems to help me

Gurux · « **Reply #3 on:** February 07, 2004, 04:05:00 PM »

man i jus bridged bothe traces and i cleaned them very well and it still wont flash and it is a winbon chip

Gurux · « **Reply #4 on:** February 07, 2004, 04:29:00 PM »

man i jus bridged bothe traces and i cleaned them very well and it still wont flash and it is a winbon chip

teknojuce · « **Reply #5 on:** February 07, 2004, 11:00:00 PM »

Yiddleja · « **Reply #6 on:** February 08, 2004, 02:58:00 AM »

terrorvis · « **Reply #7 on:** February 08, 2004, 05:43:00 AM »

lordvader129 · « **Reply #8 on:** February 08, 2004, 12:37:00 PM »

if the soldering is wrong it woul dprobably recognize as the ol' 0x0900 "Winbond"

Gurux · « **Reply #9 on:** February 08, 2004, 01:45:00 PM »

ok i got the 077 hack to udata and booted up my xbox and it flashed my chip all done

Author Topic: What Are The Correct Tsop Enable Points On A V1.2 (Read 108 times)