before i try anything i would like to verify this. please, if someone says its rite, then reply with your opinion so i can get more than one "OKAY'S".
this is wat im going to do:
i want to split my tsop in half (two 512's) with a switch that has three prongs. the middle goes to a19 and the two sides go to gnd and vcc.
is that the rite setup? or should i do it another way?
also...
should i solder the wires to a19,gnd,vcc and also the jumpers for write access all at the same time? or should i put the switch, see if it works, then jumper the points for tsop flashing?
please... someone give me there opinion in detail.
thanks
