xboxscene.org forums

Author Topic: Help Plz  (Read 66 times)

a9h3x

  • Archived User
  • Jr. Member
  • *
  • Posts: 75
Help Plz
« on: July 27, 2003, 08:03:00 PM »
ok i've got my solder perfect on the top points specified.. for the 1.2 and ive done all 3 points but took the bottom off bc it wasnt working... so now i have the top two points specified by the pinned 1.2 raincoat guide.. but when i try to flash the bios this is what i get..


# ./raincoat -p bios.bin
raincoat Flasher  0.5  Apr 14 2003  [email protected]  http://xbox-linux.sf.net
Reading /etc/raincoat.conf... (unable to open /etc/raincoat.conf, using default
list)

UNKNOWN DEVICE Read Only??? manf=0x09, dev=0x00
Try adding the device ID to /etc/raincoat.conf
#

also..I have put raincoat.conf in the etc dir i made one, and i have it in the folder with raincoat, and ive added the values into the conf.. help!!
Logged

Frag Daddy

  • Archived User
  • Sr. Member
  • *
  • Posts: 326
Help Plz
« Reply #1 on: July 28, 2003, 12:33:00 PM »
What type of tsop do you have?   Because you've updated the raincoat.conf, it means that your points aren't bridged correctly if you keep getting the unknown device message.
Logged

PsiDOC

  • Archived User
  • Full Member
  • *
  • Posts: 187
Help Plz
« Reply #2 on: July 28, 2003, 12:50:00 PM »
QUOTE
manf=0x09, dev=0x00


That's the standard ID reply from all bioses when the write enable jumpers are not correctly set.
Please check your soldering.
Regards,
Psi
Logged