Topic: 007raincoat Does Not Work For V1.1 With Sharp Bios (Read 150 times)

kain · « **on:** July 07, 2003, 04:53:00 PM »

anyone

PSXCopyCat · « **Reply #1 on:** July 07, 2003, 07:13:00 PM »

jumper ars in the 2 points on top and bottom or jumper as to the extra wire needed for power?

smokeingit · « **Reply #2 on:** July 07, 2003, 09:35:00 PM »

how do you know it does not work? cause i modded a shit load of sharps

craigncheri · « **Reply #3 on:** July 08, 2003, 07:42:00 AM »

I've done 3 1.1's with sharp tsop's now using raincoat and the 007 trick
this is what I did.
when both jumpers were closed machine refused to boot on the retail bios so I had to leave the top jumper open to get the machine to boot.
(you may or may not need to do this)

I soldered a jumperwire on the bottom of the board to provide the voltage needed for the sharp tsop. there are diagrams of this in the tutorials section

booted 007 and performed hack as normal except right before pressing enter on the ./raincoat -p bios.bin command I had a friend hold a small flat bladed screwdriver across the write jumper points on the top side the board. (remember my machine wouldn't boot with these points shorted)

kain · « **Reply #4 on:** July 08, 2003, 08:33:00 AM »

QUOTE (craigncheri @ Jul 8 2003, 03:42 PM)

I've done 3 1.1's with sharp tsop's now using raincoat and the 007 trick
this is what I did.
when both jumpers were closed machine refused to boot on the retail bios so I had to leave the top jumper open to get the machine to boot.
(you may or may not need to do this)

I soldered a jumperwire on the bottom of the board to provide the voltage needed for the sharp tsop. there are diagrams of this in the tutorials section

booted 007 and performed hack as normal except right before pressing enter on the ./raincoat -p bios.bin command I had a friend hold a small flat bladed screwdriver across the write jumper points on the top side the board. (remember my machine wouldn't boot with these points shorted)

Thanks god that some here knows what im talking about.
thanks Ill try that

kain · « **Reply #5 on:** July 08, 2003, 08:58:00 PM »

craigncheri your the man

smokeingit · « **Reply #6 on:** July 08, 2003, 09:09:00 PM »

Jesus.... everyone knows that... fucking do a search. i didnt read that you could not get it to boot in the first place. its well known if you do a search
http://forums.xbox-s...=tsop,and,sharp
http://forums.xbox-s...=tsop,and,sharp
http://forums.xbox-s...=tsop,and,sharp

well anyways, the way us modders do it is by giving it the needed 5+ voltage and also leaving 1 undo write enable open. after it boot close it. i had to use a switch

Author Topic: 007raincoat Does Not Work For V1.1 With Sharp Bios (Read 150 times)