Topic: About To Flash A Tsop (Read 103 times)

jp110099 · « **on:** June 02, 2003, 01:14:00 PM »

1. Bridge the write lines on the bottom

2. Boot up

3. Bridge the points on the top.

4. Go into AUF and boot linux through the save game w/ raincoat

5. make sure my pc is 192.168.0.* (what if it is 192.168.1.*?)

6. Assuming my PC is 192.168.0.* then open a dos prompt and type (w/o quotes) "telnet 192.168.0.64"

7. Then type username: root, password: xbox

8. then (w/o quotes) "cd ../../media/E/UDATA/4541000d/000000000000/raincoat"

9. then type (w/o quotes) "./raincoat -p xbox.bin"

after that it shud erase and flash the TSOP then will it tell me wen its done? and wen i boot EvoX I can flash it w/ a 1MB version (v1.0,1.1) or 256k (v1.2) of the X2 4976.02?

also the bios file is called "bios.bin" should i type "./raincoat -p bios.bin" instead of "./raincoat -p xbox.bin"?

What are the odds of it fvcking up if i follow this list to the letter?

The save w/ raincoat (wtf is a "raincoat") is 7.44mb so will it fit on an 8MB M$, obviously u wud jump to the conclusion and say "YES!!!" but my CF card is 128MB and is only 121MB due to different ways of measuring bytes and kilobytes.

Thx a lot.

deadspider · « **Reply #1 on:** June 02, 2003, 01:37:00 PM »

bridge BOTH bottom and top
copy the game save file to hard drive and yes it will fit on a 8mb card i used madcatz card
make sure you PC IP is 192.168.0.1
load agent under file game fom hard drive waite till you get a black screen and sounds
open dos type telnet 192.168.0.64
then root then xbox
if the bridge is OK you will NOT get an error if you do your not connected so sodor again
TYPE cd ../../media/E/UDATA/4541000d/000000000000/raincoat
then TYPE ./raincoat -p bios.bin
DO NOT TYPE ./raincoat -p xbox.bin
and then your done !!!
you can replace the 1mb bios in raincoat folder with the latest bios so you dont have to reflash it again !
MAKE SURE ITS A 1MB BIOS or you will F up

jp110099 · « **Reply #2 on:** June 02, 2003, 03:44:00 PM »

i heard it was safer to use the BIOS that it came with, just in case, and i read that u shud only bridge one or else it frags so u hafta start up first then bridge.

deadspider · « **Reply #3 on:** June 02, 2003, 04:58:00 PM »

well i dont know where you hear only to bridge half only but what i wrote worked for me !
as for bios as long as you know youve got a working bios i dont see anything wrong with it as i did and it worked for me

deadspider · « **Reply #4 on:** June 02, 2003, 05:52:00 PM »

cribby08 · « **Reply #5 on:** June 02, 2003, 05:55:00 PM »

Ya, you know its very easy to do once you figure it out. You cannot be so scared to try stuff, just go for it and you will be OK.

Author Topic: About To Flash A Tsop (Read 103 times)