Topic: Flash Xbox 1.2 With 007raincoat (Read 503 times)

Makanic · « **Reply #60 on:** November 10, 2003, 03:42:00 PM »

Flashed Tsop
Used EvoX & 007
Used Only The Top 2 Pionts
(Bottom Piont is the Same as top:)
worked sweet on
Hynix-hy29f002 Bio Ver 4977
& 2 Others.....Same Brand Tsop l Think???
HAvent gotem to Check

No Joy with
Windbond w49F020T Bio Ver 5101 or
Windbond w49F020T Bio Ver 5530
will Have to try & Use Raincoat!

Does Anyone Know if Raincoat Will Flash
Windbond w49F020T Bio Ver 5530

As with EvoX The Message l Get Is
Bio Ver "UnKnown"
Kernel Ver 1.00.5530.01
ID da Device ID 8c
2003-9-23 MFG

Do l just add ID da & Device Id 8c & where is has the Chip Name Goes eg:Hynix-hy29f002 do l add "UnKnown"

Any help would be good

Thanks in Advance

Makanic · « **Reply #61 on:** November 10, 2003, 07:26:00 PM »

Tried to flash

Windbond w49F020T Bio Ver 5530
Kernel Ver 1.00.5530.01
ID da Device ID 8c
2003-9-23 MFG

No Joy

Dead Unit

Used Raincoat ,
Blanked & Copyed Bios Said it was OK...
rebooted Xbox....Flashing Red Light of DEATH...

NOt HAppy

ANyone with any Help?

kard63 · « **Reply #62 on:** November 28, 2003, 07:55:00 PM »

Whats with all the talk about 'top' and 'bottom' on the mobo. There is one pair of points that need to be bridged and another pair somewhat below it right? You don't actually have to flip the damn mobo right? and do it on back? I hope not.

lordvader129 · « **Reply #63 on:** December 05, 2003, 02:22:00 PM »

thats probably them

the jumper points are two small soldering pads, they dont look like any other points nearby

Xboxman20 · « **Reply #64 on:** December 12, 2003, 01:54:00 PM »

Kard63

There is a set of jumpers on the top of the motherboard and a set on the bottom so yes you have to flly take out the mobo to do this.

maurinan · « **Reply #65 on:** December 16, 2003, 05:54:00 AM »

Anybody knows how to copy file raincoat.conf in /etc/

?
THX

Author Topic: Flash Xbox 1.2 With 007raincoat (Read 503 times)