Topic: Xenium Gold Install Problem (Read 131 times)

MagusCole · « **on:** September 27, 2006, 02:51:00 PM »

I just installed the xenium gold solderless on my xbox. I got the OS screen for xenium to load, but I needed to switch the dvd-rom with my new hard drive to use. I shut off my xbox, switched out the dvd-rom drive for the hard drive, but When i rebooted my xbox reboots twice and then it flashes red and green. The led for the xenium comes on red, but I get no OS come up on my tv. d0 is in place, any idea what the problem may be?

proctorbc2005 · « **Reply #1 on:** September 27, 2006, 05:15:00 PM »

Does switching the The hard drive and DVD drive again fix the problem? IF it does you may have a bad IDE cable. IF it dose not fix it, you may have dislodged the chip somehow, try and reseat it.

MagusCole · « **Reply #2 on:** September 27, 2006, 05:28:00 PM »

I am using a solderless adapter. Thats the only thing I could think of that may be giving me trouble. When I hook everything back up to normal it still gives me the flashing red and green.

CJLee89 · « **Reply #3 on:** September 27, 2006, 05:42:00 PM »

that has nothing to do with your drives. take everything off and reinstall it. check that everything is connected good.

MagusCole · « **Reply #4 on:** September 27, 2006, 05:46:00 PM »

I disconnected everything and checked it all to make sure it is connected tight, which it is. But I still get the error. Reboots twice, then flashes green and red.

CJLee89 · « **Reply #5 on:** September 27, 2006, 05:49:00 PM »

i would say take the chip completely. and boot xbox without it. and post back with the results. any error codes/screens, what happens on the P/E LED etc. etc.

MagusCole · « **Reply #6 on:** September 28, 2006, 12:20:00 PM »

Ok I fixed it. It turns out I had the ribbons reversed. I have my chip installed now with everything functionable, I have my ftp working but now when I go to drag and drop files onto my xbox, nothing shows up. It says it transfered the files but I dont see them. I am using flashFXP.

CJLee89 · « **Reply #7 on:** September 28, 2006, 01:53:00 PM »

make sure you have passive mode turned off in FlashFXP.

MagusCole · « **Reply #8 on:** September 28, 2006, 02:04:00 PM »

Ok I am able to see the stuff that I add when I am in the bios Xenium menu under lanch menu, then add new item then flash and choose a drive. How I am able to see this stuff under the flashFXP program?

CJLee89 · « **Reply #9 on:** September 28, 2006, 02:20:00 PM »

turn off "use passive mode" in FlashFXP settings.

This post has been edited by CJLee89: Sep 28 2006, 09:20 PM

Author Topic: Xenium Gold Install Problem (Read 131 times)