Topic: 1.6 Rebuild, D0 Question (Read 74 times)

Grim187 · « **on:** June 03, 2006, 11:49:00 PM »

I'm installing a Xenium Ice on my friends xbox for him, its a 1.6 i just opened it like a hour ago found that tut to rebuild it, did then i get to the d0 point and i cant seem to get solder on that tiny hole so i tried putting some of my solderless d0 wire in there but i couldn't get it to go and lost it, and i cant find the alternate d0 wire on the back,

so basically what i need to know is aether how to solder in that tiny hole or where the alternate d0 is on the 1.6

p.s. its a 1.6 not 1.6b

thanks in advanced

Grim187 · « **Reply #1 on:** June 04, 2006, 01:30:00 AM »

never mind i found the alternate d0 here it is if anyone needs it

http://www.fixnchipz.../wpde6aa293.jpg

P.S. sorry about talking about a xudos chip in the Xecuter Forums i always Go in to the wrong forum, my bad

Grim187 · « **Reply #2 on:** June 04, 2006, 03:28:00 AM »

OK down with that problem and up with another,

i got everything in there right i checked 5x (had to lift and repair a broken trace, lad2, i think i did a pretty good job, not like it gos anywhere)
i put the chip in and boots 2sec powers down 3x then frag and powers down and boots fine without the chip, so i'm not sure what i could have done wrong, well i think i'm doing something wrong it is 3 in the morning...lol, o well I'm off to bed hope you guys have some ideas for me when i wake up

thanks for the help now and always

saint_river · « **Reply #3 on:** June 04, 2006, 02:44:00 PM »

all you need to know in this link
http://www.team-xecu...7e1e5139ddb1bb3

appleguru · « **Reply #4 on:** June 04, 2006, 03:17:00 PM »

Moving to Xenium forum...

Grim187 · « **Reply #5 on:** June 04, 2006, 05:17:00 PM »

thank you, I'm using This Guide, Ive tried just about everything, i did have it working for about 5sec i think my main problem is aether purple or d0, the best i have been able to get in the terms of lights is Red-Yellow Shuts down I'm assuming this means that I'm one away or that there isn't enough amperage, i have the d0 yellow and blue on top and the rest on the bottom, I'm still in the process of moving them all to the top since i have riped out the solder hole for purple on the bottom and completely messed up a trace (lifted and fixed thank god), i just cant get it out of my mind how much easyer installing the pinheader on my 1.0

Grim187 · « **Reply #6 on:** June 04, 2006, 08:12:00 PM »

QUOTE(richman246 @ Jun 4 2006, 06:56 PM)

If it's fragging 3 times, it sounds like the problem some others were having. Try cleaning the Rivets really well. Some people did that and it worked. good luck

what, im doing the 1.6 rebuild i dont have the solderless

Grim187 · « **Reply #7 on:** June 05, 2006, 01:54:00 PM »

i had removed the opisit side pin, i got it working now

Author Topic: 1.6 Rebuild, D0 Question (Read 74 times)