Print

[WermX]

My install:
I could never just get the chip working soldering it straight to the d0. I had to plug in the quick disconnect d0, take the blue wire and solder to the d0, and then take the black wire and solder into ground.

My problem now:
This mod chip worked fine until last night. the D0 circuit got fried on the back of the chip, so I soldered a wire from the d0 to where it was going heres a pic of what I did:


click the image for a larger view please.
As you can see, I soldered a wire from the D0 point on the back of the chip to the point it lead to.
Sometimes it frags and turns red and other times it loads the MSdash and dosen't frag. Right now it's fragging 100%.
I reinstalled it using the same quick disconnect method.
anyone have any ideas?