Topic: Sp Ice On A 1.0 (Read 34 times)

Rabid1 · « **Reply #15 on:** November 10, 2005, 08:30:00 PM »

I will have to check, but I thought I put something like this in that link:

Xbox front, from top:

1 2
3 4
5 6
7 8
9 10
11 12
13 14
15 16
screw

It could be pin 2 or 9.
If the black adapter and the white LED board came together it makes me curious if you got a used adapter. they normally come seperate with popcorn on the wires.
Also check continuity on pins 2 and 9 top to bottom.

ltcolfury · « **Reply #16 on:** November 11, 2005, 02:27:00 PM »

I tested #9 on the LPC and grounded the other line and I get a quick beep. (continuity) Is #9 supposed to just give off a quick beep? (but i get a reading after that on the meter, just no sound)

When I test #2 on the chip to the hook I get nothing but I am sure that is nothing to be conserned about. (WIth chip off mobo) I just thought I'd mention it.

It seems that #2 could be the problem. This particular hole has the solder down about 1/4 of the way. I don't believe that the prong (I don't know what to call it) is not getting contact when placed on the Mobo. It is possible.

I have a friend of mine coming over tonight (Electronics guy but not a gamer) to look at the continuity stuff and to see what other issues could be causing this. All I do is tell him what it is supposed to do.

Maybe #2 needs that Xacto you mentioned. (?)

Is it sensible to "remove" the solder from any of these holes and stick in the rivets? (Mainly #2 & #9)

On my Xbox (v1.1) all I did was use 3 rivets in #'s 1, 2 and 9 I think) I followed the directions but don't remember which ones they were off hand. It could have been 14, & 15, not sure)

Thanks again.

ltcolfury · « **Reply #17 on:** November 11, 2005, 11:17:00 PM »

All went smoothly and it is now working. My friend used a solder sucker and removed the solder in the LPC. Put the chip on and it worked right away.

My only issue is this: after installing Slayers disk, (which took an hour & a half...dang Thomson drive) I get an error 21 before loading the EvoX dash.

Have you ever heard of this error?

Thank you very much to the both of you for your excellent assistance and advice. I couldn't have done it without you.

ltcolfury · « **Reply #18 on:** November 12, 2005, 08:22:00 PM »

I will give advice to others now that I went through this twice and feel comfortable with the process now.

Author Topic: Sp Ice On A 1.0 (Read 34 times)