Topic: Help On Xenium Spice Installation (Read 37 times)

pezzar · « **on:** October 31, 2005, 03:10:00 PM »

the gold wires should just seat inside the holes. the holes may be covered with lacquer so clean them up first with a fibre glass prep pen and some surgical spirit

skaterbasist · « **Reply #1 on:** October 31, 2005, 03:19:00 PM »

So you are suggesting me to clear the holes open with some sort of pin? am i suppose to penetrate the pin until it goes thru the motherboard? Im a total noob to this, so thanks for your suggestions

skaterbasist · « **Reply #2 on:** October 31, 2005, 04:03:00 PM »

Can i use a needle to clear lacquer from the covered holes on the motherboard?

I need so much help!

SegmentationFault · « **Reply #3 on:** November 02, 2005, 12:14:00 PM »

Use a fibreglass pen to gently scrub the via. With the right tools it shouldnt be hard.

A pin really isnt the right tool, not sure if it will work. A fibreglass pen is static free and there is less of a chance that you could screw things up.

pezzar · « **Reply #4 on:** November 03, 2005, 03:43:00 PM »

i use a pin to break the lacquer, just be careful not to open the hole up otherwise the wire will be too loose then

Author Topic: Help On Xenium Spice Installation (Read 37 times)