Topic: Solderless Adapter (Read 94 times)

JamesKJeep · « **on:** March 24, 2005, 07:03:00 PM »

anybody

JamesKJeep · « **Reply #1 on:** March 24, 2005, 07:57:00 PM »

I can not get that last pin in could my soulderless adapter be messed up?

acemilo · « **Reply #2 on:** March 24, 2005, 09:40:00 PM »

Use a razor to scrape it out, or solder it in. And don't bump your topic so much.

acemilo · « **Reply #3 on:** March 24, 2005, 10:22:00 PM »

1 bump per day is all that is allowed unless you are responding. Your just gonna have to try scraping the laquer with a razor until the copper is exposed.

dartainia · « **Reply #4 on:** March 24, 2005, 10:42:00 PM »

QUOTE(JamesKJeep @ Mar 25 2005, 05:33 AM)

are you talking about the little hole where the copper wire goes. If you are man the hole is to small for a razor to fit

Rabid1 · « **Reply #5 on:** March 24, 2005, 11:12:00 PM »

QUOTE(dartainia @ Mar 25 2005, 05:48 AM)

Set the corner of the razor blade in the hole and slowly rotate on its axis while apply very slight pressure. You shouldn't even have to do this, the wire is supposed to snap into the hole while apply slight downward pressure on the wire.

acemilo · « **Reply #6 on:** March 25, 2005, 02:10:00 PM »

We gave you all the advice we can. Your either gonna have to keep trying to get it to stay, or bring it to someone else to have them put it in for you.

JamesKJeep · « **Reply #7 on:** March 25, 2005, 09:38:00 PM »

QUOTE(acemilo @ Mar 25 2005, 04:16 PM)

We gave you all the advice we can. Your either gonna have to keep trying to get it to stay, or bring it to someone else to have them put it in for you.

Author Topic: Solderless Adapter (Read 94 times)