xboxscene.org forums

Author Topic: Xbox Startup Problem  (Read 23 times)

HoSqueek

  • Archived User
  • Newbie
  • *
  • Posts: 1
Xbox Startup Problem
« on: January 06, 2005, 09:08:00 AM »
hey i'm modding a v 1.5 xbox and was using the xenium ice solderless adapter...the board was covered with that green stuff so i cleaned it off of the DO hole but the wire wouldn't go in very tight....it would work sometimes but not others....so a friend of mine was going to put a little solder on it to hold it in place but couldn't get the solder to stick. The xbox wouldn't even boot to xenium sometimes like previously so i removed the modchip, and solderless adapter, i think it should now just run like a stock xbox correct? But when i turn it on it does the frag 3 times then turn off bull shit. Any idea how to get this fixed, please get back to me on this.
Logged

MitHriDate

  • Archived User
  • Newbie
  • *
  • Posts: 11
Xbox Startup Problem
« Reply #1 on: January 06, 2005, 12:06:00 PM »
Sounds like you may have damaged the mother board when trying to clean it.  I would check all the traces around the area you were working.
Logged

Elf_Sniper

  • Archived User
  • Full Member
  • *
  • Posts: 172
Xbox Startup Problem
« Reply #2 on: January 06, 2005, 12:56:00 PM »
You need two extra connections for a v1.5

Ground and v3.3, I believe.
Logged