Topic: I Installed It Wrong... (Read 189 times)

allholy1 · « **Reply #15 on:** December 16, 2004, 11:35:00 AM »

Also, when I unplug the d0 connector, the xbox boots fine, with the chip LED turning red.... could it be a faulty chip? Or could it be a bad d0 connection?

flbeserk · « **Reply #16 on:** December 16, 2004, 02:07:00 PM »

it's most likely somethigs wrong with the chip, but try another wire to connect to d0. if you want, I don't know what else to say.

Sabre22 · « **Reply #17 on:** December 16, 2004, 04:44:00 PM »

allholy1, is your MB a version 1.6? If so why don't you buy the LCP board made for the 1.6? You don't have to worry about wires shorting or hooking up to the wrong pad.

S

flbeserk · « **Reply #18 on:** December 16, 2004, 07:19:00 PM »

solderless isn't so good, they recommend you solder it, why don't you get someone to solder it for you? there are alot of experienced modders on these forums.

flbeserk · « **Reply #19 on:** December 16, 2004, 08:56:00 PM »

not sure but i suppose so, soldering isn't hard and it shouldn't cost so much money for someone else to do it for you.

Silentscream__ · « **Reply #20 on:** December 20, 2004, 04:24:00 AM »

sounds like a bad chip. Flip the switch on the actual chip and see if you get the recovery screen. If you do, then i would suggest burning the xenium OS to a disk and then using it to update the chip. if this doesnt work, then it is possible that you have a dodgy or fake chip. You can get the latest Xenium OS from www.teamxodus.com

Author Topic: I Installed It Wrong... (Read 189 times)