Topic: Ice Chip Boot's To Main Menu Then Nothing (Read 41 times)

ltoolio · « **on:** November 17, 2004, 03:19:00 PM »

Two things:

1. Have you tried updating via CDRW in recovery mode.
2. (and I'm not 100% sure of this one)did you solder the additional points necessary for the V1.5. it is mentioned on page 22 of the IceGuide by cap269?

joker81 · « **Reply #1 on:** November 18, 2004, 11:36:00 PM »

I was reading the install manual and for the v1.5 you have to do extra things to it. So maybe thats the problem im not sure tho.

rd350ypvs · « **Reply #2 on:** November 19, 2004, 02:58:00 AM »

you need 2 additional points, 3.3v and ground when using a 1.5 xbox

andyw

appleguru · « **Reply #3 on:** November 19, 2004, 05:20:00 AM »

It's most likely a 1.4...

Anyways, try a different controller if you can find one, and as ltoolio said, try updating to XOS 2.0.1.

fricfrac · « **Reply #4 on:** November 21, 2004, 08:13:00 AM »

Bump!

anticrap1234 · « **Reply #5 on:** November 21, 2004, 11:23:00 AM »

well use arrows to scroll not joystick. And if u installed the little pins under the solderless adapter take them out all i did is place in do point press adapter ino hole screw in. But to boot u need to set up tsop. Maybe ur chip is screwed talk to seller

appleguru · « **Reply #6 on:** November 21, 2004, 01:37:00 PM »

No, your chip is fine. As anticrap1234 suggested, be sure you're using the d-pad arrows and not they joystick 8-)

appleguru · « **Reply #7 on:** November 21, 2004, 03:23:00 PM »

Well, try using the webinterface to add/boot a bios and see if that works... if it does, then it's definitely your controller(s), if it doesn't then it's likely your install or xbox...

appleguru · « **Reply #8 on:** December 11, 2004, 11:38:00 PM »

Silentscream__ · « **Reply #9 on:** December 12, 2004, 11:19:00 AM »

I had the exact same problem, just updated to 2.01 and everything works fine.

Author Topic: Ice Chip Boot's To Main Menu Then Nothing (Read 41 times)