Topic: Need Help With Problems After Chip Install Please (Read 59 times)

Shadowblade · « **Reply #1 on:** October 03, 2004, 09:09:00 AM »

Didn't the topic of the other threads in this forum make you think "hey, maybe installing a modchip isn't considered a casemod." Seriously, scroll down and look at the names of all the forums before posting. There is a forum specifically for zenium chips...

No_Remorse_666 · « **Reply #2 on:** October 03, 2004, 11:28:00 AM »

appleguru · « **Reply #3 on:** October 03, 2004, 06:28:00 PM »

Your PSU could have blown it's (Very finicky) 2A fuse... Do the xbox's LEDs power on at all?

HooHAster · « **Reply #4 on:** October 04, 2004, 05:36:00 PM »

Is there a way to fix this or should I de-solder everything and take the chip off? Is it possible to back everything out and still have a functional normal xbox (assuming it's not broken)?

Gumba · « **Reply #5 on:** October 04, 2004, 10:26:00 PM »

How To Resurrect A Dead 1.6 - by Team Xodus, w/ Llamma Intro
http://www.llamma.co...ox_no_power.htm

Knocker_Nutz · « **Reply #6 on:** October 08, 2004, 09:55:00 PM »

unplug the power cord from the back of the xbox and then plug it back in. See what it does. I have the same problem, but if I unplug it then plug it back in it powers up by itself.

X3rules · « **Reply #7 on:** October 08, 2004, 10:15:00 PM »

Did you mention you were playing this game from the hard drive or from a backup DVD. Just wondering if you got a good clean ISO burn. If you are playing from DVD try installing onto your hard drive and see if you run into the same problem. Try reburning onto a DVD-RW at the slowest speed and see if that helps.
I'm assuming your not having this problem with other games.
Did you forget to plug you fan back wire back in.

HooHAster · « **Reply #8 on:** October 10, 2004, 04:48:00 PM »

I tried doing the upplug/plug back in thing and that didn't work.

I double checked all wires and everything is plugged in properly.

I tried the link Gumba posted and that's not the problem. I measured the voltage like it said and I'm getting a constant 3.25v, which is correct.

Maybe my power supply went out?

Are there any places that do repair services (other than Llama which I already looked at)? Is this a viable option b/c I really have no clue what to check next?

Thanks all.

bigjoe2000 · « **Reply #9 on:** December 26, 2004, 01:40:00 PM »

Author Topic: Need Help With Problems After Chip Install Please (Read 59 times)