Topic: Xenuim Whitte/light Blue Led (Read 80 times)

marksu · « **on:** May 24, 2004, 11:46:00 AM »

How about did you use the rivets?

marksu · « **Reply #1 on:** May 24, 2004, 12:06:00 PM »

Here is some eject lead codes.

It says following:
Flashing RED & GREEN (FRAG): Probably a bad chip or bad installation, FRAG indicates that your d0 wire is installed correctly.

Check that the Xenium is installed correctly and that its LED is lit Red.
Realign the solderless adaptor on the LPC points.

Sorry cant help more than that.

marksu · « **Reply #2 on:** May 24, 2004, 01:00:00 PM »

Well as far as I know the xenium led light codes have not been published.
People have been asking about them before but no response.

marksu · « **Reply #3 on:** May 24, 2004, 08:45:00 PM »

Well where did you buy it.
It could be a clone.
The clones usually work couple of weeeks and then they die!
Check here for the 2 different clone versions in case you have it?
http://forums.xbox-s...howtopic=189816

It been extreamly rear that the non clones get broken.
Clone die all the time.
If it is not clone you could try using pinheader install if not to afraif of soldering.

But understand you might not want to solder.

marksu · « **Reply #4 on:** May 27, 2004, 09:45:00 AM »

Nice that your got the problem ficured out.

Yours is the first proven bad Xenium mod I have encountered on this forum (quite rear).
Thanks for sharing your info.

marksu · « **Reply #5 on:** May 27, 2004, 09:51:00 AM »

We are trying to figure out that double wire thing to on following THREAD.

If you figure it out post info on that thread.

da_hammer · « **Reply #6 on:** May 28, 2004, 02:20:00 AM »

i sure will......

Author Topic: Xenuim Whitte/light Blue Led (Read 80 times)