Topic: Problem With Xenium (Read 72 times)

cap269 · « **on:** April 10, 2004, 06:09:00 AM »

after you have loaded the BIOS file from either CD or HD, are you then selecting "Program Flash" from the Xenium menu ?

cap269 · « **Reply #1 on:** April 10, 2004, 12:44:00 PM »

Have you checked to make sure it isn't a fake chip?

Hellstream · « **Reply #2 on:** April 10, 2004, 07:43:00 PM »

OK I resoldered the LPC points and it is still turning on and shutting off a few times but when it stays on it always goes into the OS. None of the bios' I have loaded into the banks do anything and neither does the original bios. All of them when selected reboot the xbox to a black screen.

So here is the run down so far:

-XBOX v 1.4
-Xenium 4th gen chip (not a fake) mounted using quick solder pads and top D0 (all solder points have been triple checked)
-Xenium OS is version 1.1
-using standard AV cable
-I have tried the original bios, x2 4983.67 Evox M7 and Evox M7 EF and all leave me at a blank screen and a red led on the chip
-I can't check the front panel to see what colors are showing up because the leds have been removed for a led color change

Thats pretty much it so far.

Just a thought...would a damaged trace do something like this? I may have messed up the bottom D0 point. Thats where I was initially trying to solder to but the wire wouldn't stay secure.

Hellstream · « **Reply #3 on:** April 11, 2004, 05:31:00 PM »

::bump::

EmperorPsiblade · « **Reply #4 on:** April 11, 2004, 05:41:00 PM »

sounds like a D0 problem.....

Hellstream · « **Reply #5 on:** April 11, 2004, 08:16:00 PM »

Author Topic: Problem With Xenium (Read 72 times)