Print

[Master-Chief]

[Master-Chief]

QUOTE (Cavalierz24 @ Apr 8 2004, 06:52 PM)

If the alternate d0 didn't work it wouldn't be much of an alternate now would it?

The TOP d0 didn't work (the d0 on the top side of the mobo). I was wondering if soldering it to the Alt. d0 would do the job... so I tried it... results are that it still frags...  

[EmperorPsiblade]

[geniusalz]

QUOTE (Master-Chief @ Apr 8 2004, 06:08 PM)

Hi, I was installing a Xenium for a friend who messed up his top d0. I installed the Xenium and I got a red LED on chip. Then I tested it and it fragged! I then proceeded to solder the d0 on top to the d0 on the Xenium. It loaded the MS BIOS and the MS Dash. When I disconnect d0 it frags. What I am wondering is if that I solder the alt. d0 point to the d0 on the Xenium if that will work? Also, would I be able to use Xbox Live if I did this? Thanks for you help guys!

It shouldn't frag if the d0 is disconnected.  Try repairing the trace, or get someone to repair it.  Or it just might have a corrupt bios on the tsop (which it shouldn't, because you say it boots to msdash if d0 is on the chip)

[Master-Chief]

QUOTE (geniusalz @ Apr 8 2004, 09:55 PM)

It shouldn't frag if the d0 is disconnected.  Try repairing the trace, or get someone to repair it.  Or it just might have a corrupt bios on the tsop (which it shouldn't, because you say it boots to msdash if d0 is on the chip)

I'd rather get someone else to repair it!