xboxscene.org forums

Author Topic: Xemium Install Problem  (Read 74 times)

alwaysonjohn

  • Archived User
  • Full Member
  • *
  • Posts: 193
Xemium Install Problem
« on: January 28, 2004, 12:38:00 PM »

I got a new xbox version 1.4 or 1.5... i dunno.

Anyways tried a regular pogo pin install, my xbox fragged. so i took out the pins and quick soldered.  The fragging went away but now it boots ms.

Tried resoldering my d0 hundreds of times still nothing.  tried alt. d0, still nothing.

tried the version 1.5 instructions (soldering ground and 3.3)  still nothing besides ms.

I think the problem is that in the 1.5 instructions my Xbox Motherboard looks a little different (where the 3.3 volt point is...)  you see where it says c7d3 is in a different location?

SO what do you guys think i should do?  Do you think i got a bad chip?
Logged

alwaysonjohn

  • Archived User
  • Full Member
  • *
  • Posts: 193
Xemium Install Problem
« Reply #1 on: January 29, 2004, 03:27:00 AM »

the chip lights up?  Mine doesn't...  NO xenium os also...  sad... i will check my solder points on this new day... but like I said my mobo doesn't look like the 1.5 in these pictures.

http://www.12tre.com..._diagram1.5.jpg

my c7d3 is written somewhere else...  but pretty close..

Is there another pin that has 3.3v nearby that i can use?
Logged

alwaysonjohn

  • Archived User
  • Full Member
  • *
  • Posts: 193
Xemium Install Problem
« Reply #2 on: January 29, 2004, 06:31:00 AM »

where on the chip is the leds?

n/m i found it on the back.. one red one...  (I installed the chip on my other xbox... not working there...)
Logged