Topic: Just Installed Xenuum Need Help (Read 51 times)

Presto · « **on:** January 27, 2004, 04:11:00 PM »

i get a blue light on the chip

ravage73 · « **Reply #1 on:** January 27, 2004, 04:37:00 PM »

QUOTE (Presto @ Jan 27 2004, 09:06 PM)

I just installed an xenium into my 1.0 Xbox. When I turn it on, it turns on, then it off, then it turns on again, then turns off, then on, and it flashes red and green. i did it with the solderless adaptor what to do?

did you flash it?

djtonic · « **Reply #2 on:** January 27, 2004, 05:26:00 PM »

Its already flashed with XENIUM OS. Check your solder points.

Presto · « **Reply #3 on:** January 27, 2004, 05:34:00 PM »

do i need to remove the solder from the holes since it is a 1.0

ravage73 · « **Reply #4 on:** January 27, 2004, 07:14:00 PM »

QUOTE (Presto @ Jan 27 2004, 10:34 PM)

do i need to remove the solder from the holes since it is a 1.0

no, your do point is not connecting.

djtonic · « **Reply #5 on:** January 27, 2004, 07:20:00 PM »

yeah must be your d0. ive never used a solderless adapter so i dont know how the d0 is connected. if i were you i would just pin header it :=) more stable. I read that the cham solderless adapter doesnt work perfectly for it. ?? good luck

ravage73 · « **Reply #6 on:** January 27, 2004, 07:57:00 PM »

QUOTE (djtonic @ Jan 28 2004, 12:20 AM)

yeah must be your d0. ive never used a solderless adapter so i dont know how the d0 is connected. if i were you i would just pin header it :=) more stable. I read that the cham solderless adapter doesnt work perfectly for it. ?? good luck

i pin headered mine. works great.

unfeomateo · « **Reply #7 on:** January 29, 2004, 04:11:00 PM »

Did anyone fix the problem?

Author Topic: Just Installed Xenuum Need Help (Read 51 times)