Topic: Pin Header Install Very "wobbly" (Read 46 times)

Tidusblitz111 · « **on:** January 27, 2004, 06:44:00 AM »

If it is "wobbly" then do a quicksolder install.... much faster, and better contact. That's my only suggestion!

petegas · « **Reply #1 on:** January 27, 2004, 07:59:00 AM »

dmdmb · « **Reply #2 on:** January 27, 2004, 10:33:00 AM »

Use more solder. Mine moved around a bit and I had trouble getting the chip to power up right until I stopped being afraid to put a little solder in there. Remeber you got to get solder up in the PINs and around the base.

Strud1512 · « **Reply #3 on:** January 27, 2004, 12:34:00 PM »

QUOTE (dmdmb @ Jan 27 2004, 08:33 PM)

Use more solder. Mine moved around a bit and I had trouble getting the chip to power up right until I stopped being afraid to put a little solder in there. Remeber you got to get solder up in the PINs and around the base.

He is referring to the chip on the pinheader, not the pinheader-LPC connection.

Really, this is how most/all pinheader installs are. If you are worried about it tilting/losing connection just do what 'petegas' suggested and use some tape - it does not take much to hold it in place.

the_titans · « **Reply #4 on:** January 30, 2004, 11:23:00 AM »

Carefully bend the outer two pins ever so slightly and reinsert the mod, by bending the pins you get a tigher fit.

Author Topic: Pin Header Install Very "wobbly" (Read 46 times)