Topic: Quick Solder D0 Connection... (Read 34 times)

Tidusblitz111 · « **on:** January 22, 2004, 10:57:00 AM »

Is it me or did I see the actual modchip being soldered to the MOBO? And what can we use as a wire for d0 connection?

Tidusblitz111 · « **Reply #1 on:** January 22, 2004, 01:26:00 PM »

I don't exactly have an old Hard Drive lying around, any other suggestions? Can I pick the wire up from Radioshack?

Thanks for all your help...

No_Remorse_666 · « **Reply #2 on:** January 22, 2004, 01:41:00 PM »

Yes RadioShack carries the wire you want, Its called kynar wire.
30awg if I remember correctly.

Flagg3 · « **Reply #3 on:** January 22, 2004, 07:45:00 PM »

You really should try to avoid the quicksolder method. It's really the worst install option because once installed it's almost impossible to remove the modchip without damaging something.

If your LPC holes are filled already and you don't want to clean them for the pin header, go with the wire install. Soldering wires to the LPC bus is very easy and it makes troubleshooting much easier.

Flagg

Tidusblitz111 · « **Reply #4 on:** January 23, 2004, 08:01:00 AM »

I'm not exactly thinking of removing my Xenium anytime soon after I get it. But, how do I do the wire install, I have never done any modding before... does the chip come with the mod, I am only looking to spend 65 bucks and I have spent 7 on soldering tools.. please advise me... does it come with wires for wire install, and which method is best for a noob? I have basic soldering skills. I got my box at christmas time and it should be a 1.4/1.5

Tidusblitz111 · « **Reply #5 on:** January 23, 2004, 08:16:00 AM »

I heard that the Pin Header install is hard due tomicro bridges in solder etc. has anyone had success with the d0 and quick solder?

SerSiTiv · « **Reply #6 on:** January 23, 2004, 07:14:00 PM »

Since there is a pin header for the D0 point is it possible to just solder the D0 point to the pin headers as well and then just plug in the chip directly onto the pin headers? Just a question sorry quite noob here.

alkaholikpa · « **Reply #7 on:** January 26, 2004, 07:18:00 AM »

Yeah it's very possible, this shows you how to do it: http://www.ozxodus.c...op=getit&lid=24

Author Topic: Quick Solder D0 Connection... (Read 34 times)