Topic: Xecuter 2.6 Install On V1.6 Xbox Using Pogo Thingy? (Read 61 times)

paybac · « **on:** March 11, 2010, 11:24:00 PM »

Other day i fried by mobo in my v1.1 ended up getting a new xbox which happens to be a v1.6.

My question is can i use my pogo header thingy in the v1.6?
(IMG:http://i285.photobucket.com/albums/ll67/joshsXJ/DSC01924Medium.jpg)

do i just need to pull out the no.6 pin(no.4 pogo is already gone) and cut the little d0 wire off the pogo then do the LPC rebuild?

Is this the best tut to follow?
X3 install tut?

Cheers
Paybac

paybac · « **Reply #1 on:** March 21, 2010, 02:29:00 PM »

Or i could just buy a pin header from my local electronics store for like $1 for a strip of 24

Dam these lpc rebuilds are hard for a newbie solderer. been practising on the fried motherboard so hopefully i won't screw it up to much.

steveo1978 · « **Reply #2 on:** March 21, 2010, 09:24:00 PM »

you can always get a solderless adapter for a 1.6

Martinchris23 · « **Reply #3 on:** March 24, 2010, 11:54:00 AM »

QUOTE(steveo1978 @ Mar 22 2010, 03:24 AM)

you can always get a solderless adapter for a 1.6

Yep, look for any sites still selling the 'Xapt3r'

Found one here, but dunno if there are others:

http://www.gocybersh...?productid=1511

paybac · « **Reply #4 on:** March 25, 2010, 02:07:00 AM »

cheers guys, not really worth sending down to New Zealand. Think i'll just practice a bit more at soldering then give it ago. Gota start somewhere

Author Topic: Xecuter 2.6 Install On V1.6 Xbox Using Pogo Thingy? (Read 61 times)