xboxscene.org forums

Author Topic: Installed Lt Opx To See A Frag  (Read 99 times)

chronotrigger681

  • Archived User
  • Full Member
  • *
  • Posts: 232
Installed Lt Opx To See A Frag
« on: August 01, 2006, 03:10:00 PM »
have you tried booting recovery mode?? Does that work?? Might wanna get out the magnifying glass and look at those solder points a lil closer. double triple check everything.
Logged

StrictPuppet

  • Recovered User
  • Hero Member
  • *
  • Posts: 1588
Installed Lt Opx To See A Frag
« Reply #1 on: August 02, 2006, 10:09:00 PM »
Did you do a pinheader install? or a direct solder to the bottom of the board?  As much as you dont wanna believe it.. its gonna be an install issue.  Check very carefully for a poor solder point or a bridged point somewhere that shouldnt be, perhaps even a missing component.  I always recommend a pinheader install, even with an opx on a 1.6, it makes trouble shooting /upgrades that much easier.
Logged