Topic: Need Urgent Help! Messed Up D0 Point On Modchip. (Read 315 times)

marshall18 · « **on:** March 02, 2010, 06:39:00 AM »

I was just soldering the D0 point connection on the top of the modchip and this happened;
IPB Image

The D0 solder point fell out, and now i'm left with a little bit of the wire coming up off the modchip. Is there any way to resurrect this or do i have to buy a new modchip? Can i soldering a pin head to the end of D0 point where there is a little hole and connect the wire to that? Suggestions please.

Marshall

memainman · « **Reply #1 on:** March 06, 2010, 05:21:00 AM »

d0* and correct. when the d0 point is grounded it allows the bypass of the TSOP. so basicly, just get the wire coming from the motherboard and solder it to the little silver plate underneath one of the screws. in my opinion, the less wires the better.

angelofhevn · « **Reply #2 on:** May 09, 2010, 08:07:00 AM »

Yes Yes this happened to my motherboard too (D0) fell of but i took with a small knife and tryed to open a gap between the board and the small lead and when i had like 0.5mm i solderred my wire to that and put a pease of electrical tape under and ower

And it held

HackDaBox · « **Reply #3 on:** May 09, 2010, 08:43:00 AM »

Simply solder your wire to the alternate d0 point shown in this picture.

http://i2.photobucke...4/duoforweb.jpg

HackDaBox !

Author Topic: Need Urgent Help! Messed Up D0 Point On Modchip. (Read 315 times)