I really pulling my hair on this one. I got a 1.6 and softmodded it first. Worked just fine. Then decided to chip it witha duox2 lite so I could easily put in a larger HDD and format it with slayer.. Everything soldered up just fine. It booted, and I started to format the new drive. All went well until the screen went blank. I tried starting over and it fragged on me. So I took it apart, inspected the solder joints on the rebuild pcb and they all lookd good. Put it back together and it booted fine again (with the evox shield). I looked like my previous atempt to format the drive worked so I installed avalaounch as my dash. Worked great. I turned it off and rebooted, fragged again. Again I took it apart, even reflowed the solder while inspecting it under a microscope. Then I read that in some cases the BT HAD to be connected. In the last Duox2 cromwells I installed, I never hooked up the bt. But I did just in case this was an anomonly ofr the Lite. It booted just fine! Now I'm a happy camper. So I load XBMC update, and start using qwix to load a few games. Whaddya know, screen goes black.
I try to reboot and get fragged. So I go to the liquer store, get some cheap whiskey and some ginger ale, make a drink and come back and turn it on. The dang thing boots fine! Turn it off, back on, and frag. Once in a great while pushing the BT button will get it to try to boot with the MS dash, but rarely, and funny thing is that it take a lot of attempts for it to eject the media disk. Any suggestions (besides giving up on modding :-) are welcome.
One last set of observations before I hit the send button.
on power on I get the three green single flashes then FRAG
If I power up withtheBT I get what appears to be one set of three quick green then four quick green flashes, then five quick green flashes followed immediatley by a FRAG.
Thanks,
-Bob