Topic: Unsuccessful Install (Read 87 times)

forget2rememb3r · « **on:** November 11, 2006, 09:50:00 PM »

I installed a duox2 chip inside a v1.2/1.3 xbox and, now, refuses to work. When I hit power, it turns on/off/on/off/on then blinks red. Before I did that, I installed a duox2 inside a v1.0 and it works just fine. I just repeated the process and now its not working. What do I need to provide ya'll with to help me? Pictures? Lots of details? I don't see how it went bad because we did the same thing (Me and my grandfather) and this one didn't work. What it because of versone differences...did I need to put the pin header in another spot. IF so, how do I fix this because..its been 2 hours and I miss it
Also, I used the same 'Alt' d0 point on both of them, could that be the problem.

Thanks in advance.

Julius Pleaser · « **Reply #1 on:** November 13, 2006, 08:19:00 AM »

Pics of your work would be helpful. As it is either your soldering that is the issue, or maybe you connected the D0 wire to the wrong pad.

forget2rememb3r · « **Reply #2 on:** November 13, 2006, 01:01:00 PM »

I know this next picture is horible but was impossible to get a clear shot. There is a dot of solder on the 4th spot by accident and then I moved on to the 3rd.

IPB Image

I'm going to try to get better pics today, but camera not the best....

forget2rememb3r · « **Reply #3 on:** November 13, 2006, 01:39:00 PM »

As you can tell, the d0 became unsoldered and I need solutions...

IPB Image

Sorry for large picture leaving for work, can ya'll tell if the trace is ripped or anything I can do to ifx it? Thanks in advance.

Author Topic: Unsuccessful Install (Read 87 times)