xboxscene.org forums

Author Topic: Duox2 Cromwell Help  (Read 57 times)

appleguru

  • Archived User
  • Hero Member
  • *
  • Posts: 1200
Duox2 Cromwell Help
« on: July 01, 2006, 09:58:00 PM »
1.6 eh.. first thing I'd try is to slide the bank switch over.. Flashbios doesn't load on 1.6s sometimes. If that fails, then you have a bad solder joint somewhere. Make sure you got all the rebuild points, reflow all the solder in the LPC holes on the rebuild pcb (This is especially important with the duox2 style rebuild pcbs), and check your soldering on the female header on the chip.
Logged

Haxor123

  • Archived User
  • Newbie
  • *
  • Posts: 1
Duox2 Cromwell Help
« Reply #1 on: July 06, 2006, 02:29:00 PM »
Well, we double checked all of the solder points again, and I can say now that there are no flaws with the soldering. However, I think there may be a problem with LPC board, which may mean that we will need to individually wire all of the circuits that the LPC board connects. But if we were to put the switch into BANK 0 mode, should the system then start with the mod chip active, or would it just be disabled?  And then how would we get the flashbios to work?
Logged