xboxscene.org forums

Author Topic: Duox2 Wont Boot With Eject Button  (Read 55 times)

drm_orac

  • Archived User
  • Newbie
  • *
  • Posts: 1
Duox2 Wont Boot With Eject Button
« on: December 29, 2005, 11:15:00 PM »
Recently installed a Duox2 (Blue) in a 1.6, then installed 120g drive and used AID installer to setup. (Used the alt BT point on underside of board)

It worked perfectly ie booted into Unleashx with power button and MSDash with eject button.

But now, it still boots fine with power button, and can load MSDash from within Unleashx, but when I try and boot from the eject button the drive opens and I get an error 05.

Do I just have to lock the drive?  Or is there something else at play here ?

I can't remember specifically locking the drive when I originally set it up.

This post has been edited by drm_orac: Dec 30 2005, 07:18 AM
Logged

edrex

  • Archived User
  • Newbie
  • *
  • Posts: 4
Duox2 Wont Boot With Eject Button
« Reply #1 on: December 29, 2005, 11:22:00 PM »
It'll take about 10 seconds to lock the hard drive and test it out.  You might as well try it and see if it works.
Logged

Chancer

  • Archived User
  • Hero Member
  • *
  • Posts: 5751
Duox2 Wont Boot With Eject Button
« Reply #2 on: December 30, 2005, 08:02:00 AM »
05 the drive is not locked. It will not boot from the MS bios with an unlocked drive.
Logged