Topic: Some One Can Help Me? (Read 87 times)

_GhOsT_ · « **on:** December 21, 2005, 03:24:00 PM »

connect the d0 to ground so it does a force boot

_GhOsT_ · « **Reply #1 on:** December 21, 2005, 11:12:00 PM »

lets try this

if the chip was flashing red that means that it was working
it should boot to the cromwell bios/flash bios if this is the first time being booted with the mod
if when it was on and just showed the default dash then the d0 (<- D zero) is most likely the problem

if the chip is flashing and the front eject light is also flashing red and green (frag) then there is a soldering error somewhere and it needs to be fixed

FSUNolez336 · « **Reply #2 on:** December 21, 2005, 11:13:00 PM »

I suggest you check out HackDaBox's website (link below). The following pitcures are the correct D0 and BT you should use.

http://www.hackdabox...x2_Install.html

Your D0...
IPB Image

Your BT...
IPB Image

natasreficul · « **Reply #3 on:** December 22, 2005, 12:28:00 AM »

i forgot well my xbox was bad tsop flashed before i install the chip and im not sure is D0 the problem or is a solder or the chip not work for me because before i install the chip it was flashing red and green no boot to m$ dash (only in my dreams) if some of those tricks not work for me im gonna prepare the shootgun and kill my self for christmas , 4 days trying to fix the holy box..no xbox no life....

thanks all of you in specia the persons who add replys to help me THANX..box

FSUNolez336 · « **Reply #4 on:** December 22, 2005, 12:40:00 AM »

Try those solder points I posted first! If that does not work, nothing will!

Author Topic: Some One Can Help Me? (Read 87 times)